DIY Snorricam mount

SNORRICAM! -
famous from requiem for a dream : http://www.youtube.com/watch?v=_9vZ-m7JSM0

Tools
- Jigsaw
- Drill and drill press
- Sandpaper
- Framing square
- Tape measure

Materials
- 1 meter long aluminum picket. Normally used as part of an outdoor deck railing.
- 3 pieces of light wood of various sizes. I took apart a box that used to contain 6 bottles of wine.
- Several different nuts, bolts, washers and L-Brackets.
- One large L-Bracket to hold the camera.
- Straps or "webbing"
- A clip for closing the belt portion
- Rubber washer for protecting the camera from getting scratched
- A bolt of the right size to hold your camera in place
- Needle and thread



there are only two pivot points. One is close to your body, the other is up by the camera. You wanna cut two half circles that will allow you to adjust the angle of your snorricam.

First cut the aluminum rail into two parts (one of 90cm, the other of 10cm). Drill a hole through one end of your rail and through the center of your half circle. Fix in place using your nuts, bolts and washers.


This is where having a drill press really helps. You wanna be able to adjust the height of your snorricam, so you need to drill some holes. Using the half circle as a guide, drill a bunch of holes around your half circle.


Attach your larger half circle to the piece of wood that will be against your body using your L-brackets.



Repeat these steps for the second pivot point
The second pivot point, closer to the camera is much like the last, just smaller. Just check out my pictures and cut/drill/sand/attach as needed!



I decided against using a second piece of wood for my back and simply use the straps to hold the snorricam to my body. The top straps form an X on my back when wearing the snorricam. The belt just helps keep it steady.

Using your drill and jigsaw, drill slots for the straps to loop through. Use some sewing skills to attach it properly.


Set up the camera mount
Attach the large L-Bracket to the 10cm piece of aluminum. This is where the camera will attach to the snorricam. Use the rubber washer to protect the camera from scratching